" /> July 2011 – Sheffield Waste Management
    28Jul, 2011
    Flood Clearance in Yorkshire

    Flood Clearance

    Flood Clearance needed

    Living in these times of climate change, we have all seen and heard of the flooding which has caused havoc across the UK.

    Airload has played its part in many of the clear up operations across Yorkshire, hiring out pumps and vacuum tankers to clean up the silt and disinfect the flooded areas.

    Working as a service provider to the highways, utilities, emergency services, steel and coal manufacturers.  

    Here at Airload we have to be able to react both quickly and effectively to minimize damage and the impact of the flood water with a cl ear flood clearance plan.

    Flood Clearance Solutions 

    Sandbag Installation Service
    Traditionally, sandbags have been used to block
doorways, drains and other openings into properties as
well as to weigh-down manhole covers, garden furniture
and to block sink, toilet and bath drains to prevent
water backing up.
• They can keep water out for short periods which
can be improved by using them in conjunction with
plastic sheeting.
• They can filter out some muddy sediments found
in flood waters.
• They are cheap and easy to install.
    If the sandbags are contaminated by flood water,
they should be disposed of safely at your nearest waste disposal site 
    or contact us  for a flood clearance plan, For more info on sandbags contact the Environment Agency 
    or Read This Sandbags and how to use them properly for flood protection
    21Jul, 2011
    Industrial vacuumation

    Here at Airload we have a wide range of vacuum equipment that we can tailor to you for the right cost, to facilitate your requirements.

    Our equipment includes a demountable vacuum suction unit which we built for specialist work it can incorporate filter hoppers for recovery and a bagging plant for repackaging of process materials couple this to our powder tanker and you can blow material back into your silo. Added to this our liquid ring tanker fleet and a skip service allows the processing of all wet and dry materials hazardous or non-hazardous.

    Airload can provide from a one off ‘deep intensive’ clean to a full time industrial cleaning contract. We have the equipment, the experience and the management skills to provide a bespoke service to your requirements and with over 30 years’ experience in Industrial vacuumation.

    8Jul, 2011
    Grease Trap Interceptor Cleaning

    Grease traps have been used since the Victorian times. They are used to reduce the amount of fats, oils and greases (FOG’s) that enter the main sewers.

    Effectively they are boxes within the drain run that are located between the sinks in a kitchen and the sewer system. They only have waste water flowing through them and are not served by any other drainage system such as toilets.

    They can be made from a number of different materials; e.g. Stainless Steel such as the Maxi-Trap design, Mild Steel, Plastics, Concrete, Cast Iron and can hold anywhere between 40 litres to 45000 litres and above. They can be located above ground, below ground, inside the kitchen or outside the building.

    Airload will thoroughly remove all of the accumulation from the top to the bottom of your grease trap interceptor. Our Grease Trap cleaning and pumping service will thoroughly remove, clean, and dispose grease, water waste and solid accumulation from the Grease Trap Interceptor system.

    Our highly skilled technicians will meticulously scuff away grease deposits and make certain that all waste is pumped out completely.

    Servicing the FOGS (Grease Trap Interceptor) device regularly can prevent solids, grease, fats, oils from contaminating your outbound lines, unpleasant smell, and old grease build up that causes costly problems.

    Never the less Airload will fully remove and haul away all the content of the Grease Trap6 Interceptor device; will do it right the first time and make sure that our clients receive the top quality that they deserve.